MAX II E-Z shift kit:
MAX II machines since the beginning have been plagued by very poor transmission shifting.
The reasons are long weak shift linkage rods with poor joints, this allows the system to
flex and deliver a lot of loose action.
Also the T-20 is best described as two transmissions in one case,
when one tries to shift a T-20 one is actually shifting two independent transmissions
in which both require the inside shift gears to be in perfect alignment in order to shift. This problem
is further compounded by the fact many machines have their idle speed set too high or the belt too
tight. This causes the transmission to turn too fast while trying to shift.
All this spells poor shifting.
Our E-Z Shift kit allows somewhat independent shifting of each side of the transmission, one side shifts
first then the other side shifts upon slight rotation of the transmission. This done by the spring loaded brass
pivots allowing each transmission side to align, therefore shifting on rotation..
The E-Z shift kit feature the main rod, springs built out of stainless steel and the pivot machined out of brass
to slow rusting down.
Operation of E-Z shift kit: While engine idling move shifter to forward or reverse and hold shifter, slightly increase RPM's
until transmission shifts. The springs allows transmission to shift independently as internal gears align.
This kit only fits the MAX II machines.
No installation directions provided as its a simple direct replacement of original linkage
Please call with any questions or concerns
812-944-1643 8am-6pm Eastern Weekdays