Description
MAX IV Splined Front and Center axle assembly Please read entire description.
Proudly
MADE IN THE USA
From your team trusted for over 49 years
6x6parts.com Richardsrelics.com ROUTE6x6.com
NEW STRONGER AXLE
Axle now includes a hub made out of solid billet steel: All one piece.
A major imporvement on orignal OEM style axles in which this hub were brittle cast iron.
Wheel flange is now 3/8″ thick, which is a major imporvement on original old style axles which were only 1/4″ thick.
These hubs are MUCH stronger than the old style cast iron hubs.
Yes: Wheel flange and reinforcement tapered hub are all machined as one piece out of SOLID steel.
Also included automotive grade wheel studs.
This solid hub detail is shown in the last photo.
These axles are use snap rings to hold sprocket in correct location, no hard to install lock collars with
set screws which rust stuck that are almost impossible to remove next time.
THESE AXLES ARE MUCH IMPOVED FROM ORIGINAL STYLE
This is a replacement upgrade solid axle with a 3/8″ 5 bolt wheel flange,
Fits only MAX IV machines with spline axles
NOTE: This is the current style of splined axle, the axle is “machined down” to take a smaller
bearing on the inside.
Note: Sprockets are held in place with snap rings not set screws in the sprockets
The axle is also drilled on the end, you you can provide a bolt and washer to help stop axle from
coming out of the inner bearing.
The needed bearing and snap ring kit is available see ” Related Products” below
Old RI part number 15538
If you have any questions as to if this part will fit your MAX, please call us at number below:
—————————————————————————————-
We stock most parts for MAX ARGO ATTEX HUSTLER TERRA TIGER AMPHICAT COOT and many other machines.
You are welcome to call us at 812-944-1643 8am-6pm Eastern Monday-Thursday
Reviews
There are no reviews yet.